Missing Toolpath List in Preview

This forum is for general discussion about Aspire
Post Reply
User avatar
SteveNelson46
Vectric Wizard
Posts: 2275
Joined: Wed Jan 04, 2012 2:43 pm
Model of CNC Machine: Camaster Stinger 1
Location: Tucson, Az.

Missing Toolpath List in Preview

Post by SteveNelson46 »

Has the show toolpath list in the preview screen been removed in V11? I turned it on in v10.5 but I can't find it in V11. Well, to be honest I can't find it in v10.5 again either.
Steve

User avatar
Adrian
Vectric Archimage
Posts: 14503
Joined: Thu Nov 23, 2006 2:19 pm
Model of CNC Machine: ShopBot PRS Alpha 96x48
Location: Surrey, UK

Re: Missing Toolpath List in Preview

Post by Adrian »

Do you mean the toolpath operations? That's a toggle in Options on the edit menu.

If you mean the actual list of toolpaths than that's there for me. Have you setup multiple sheets? By default you will only see the toolpaths for the active sheet so you may need to switch to the All Sheets view or the other sheets.

User avatar
SteveNelson46
Vectric Wizard
Posts: 2275
Joined: Wed Jan 04, 2012 2:43 pm
Model of CNC Machine: Camaster Stinger 1
Location: Tucson, Az.

Re: Missing Toolpath List in Preview

Post by SteveNelson46 »

This is a screenshot from V10.5. I only have 1 sheet.
Attachments
Toolpath list in preview.png
Missing V11.png
Steve

User avatar
dealguy11
Vectric Wizard
Posts: 2459
Joined: Tue Sep 22, 2009 9:52 pm
Model of CNC Machine: Anderson Selexx 510
Location: Henryville, PA

Re: Missing Toolpath List in Preview

Post by dealguy11 »

Try making Aspire full screen, or increasing the window height.
Steve Godding
Not all who wander (or wonder) are lost

User avatar
SteveNelson46
Vectric Wizard
Posts: 2275
Joined: Wed Jan 04, 2012 2:43 pm
Model of CNC Machine: Camaster Stinger 1
Location: Tucson, Az.

Re: Missing Toolpath List in Preview

Post by SteveNelson46 »

Thanks Steve. Your solution didn't work as I was already at max screen size. I'm using a 65" monitor set at 300 % magnification (recommended by the manufacturer). So I tried playing with the custom magnification settings. I set it to 275% and that worked so I started increasing it a little at a time. After a few tries I just reset it back to the recommend setting and everything still worked. Go figure. I thought that when I migrated to V11 the setting had been turned off. Apparently, there is no setting. What's weird is V10.5 still works fine and always did. Must have been something with internal scaling in the program.
Steve

Post Reply