Less Rapid moves?
-
- Vectric Craftsman
- Posts: 186
- Joined: Sun May 06, 2012 2:02 am
- Model of CNC Machine: Two machines, CRP 48x96 and a xylotex
Less Rapid moves?
Is there a way to cut down on all of these rapid movements in this finish toolpath setup between an inner and outer vector? Aspire 10.5
- adze_cnc
- Vectric Wizard
- Posts: 4374
- Joined: Sat Jul 27, 2013 10:08 pm
- Model of CNC Machine: AXYZ 4008
- Location: Vancouver, BC, Canada
Re: Less Rapid moves?
Probably there is a way to have fewer moves. But there is not enough information presented to give a solution.
- scotttarnor
- Vectric Wizard
- Posts: 945
- Joined: Fri Aug 30, 2019 11:40 pm
- Model of CNC Machine: Piranha XL , Shark HD520
- Location: La Crosse WI
Re: Less Rapid moves?
Scott T
@scottscnc
@scottscnc
-
- Vectric Craftsman
- Posts: 186
- Joined: Sun May 06, 2012 2:02 am
- Model of CNC Machine: Two machines, CRP 48x96 and a xylotex
Re: Less Rapid moves?
Thats because its his project and question I was trying to answer for him. Hes a new member to the forum now. This can be disregarded or deleted now.