Been working on my modeling skills again. This one pushed me, that is for sure.
It is a half model and meant to be mirrored left to right. I modeled it in Metric. Starting to get the hang of that finally. Working with the 3D printer has forced me into it. My challenge was that when I read or heard "10 mm" I had to do a bunch of math to understand the actual size. Now I am thinking what that means in my noggin. Back to the model, it is about 100mm long and about 10 mm thick. So you might want to adjust the thickness when importing. I have carved it at 10 and 5 mm, I think it looks better at 5.
Note, I may go back into the model and eliminate the two little pieces on the right end so it does not have to be mirrored.
.
.
.
.
This is my work and as usual I hereby give my permission to use it in any way you see fit.
.
.
https://1drv.ms/u/s!AtBXEhuw0FKsiKAqk-1 ... g?e=dflZvw
Non mirror version:
https://1drv.ms/u/s!AtBXEhuw0FKsiKArTGE ... Q?e=aIkMEa
Modeling a Flourish (Freebie Inside)
- TReischl
- Vectric Wizard
- Posts: 4657
- Joined: Thu Jan 18, 2007 6:04 pm
- Model of CNC Machine: 8020 48X36X7 RP 2022 UCCNC Screenset
- Location: Leland NC
Modeling a Flourish (Freebie Inside)
"If you see a good fight, get in it." Dr. Vernon Johns
-
- Vectric Wizard
- Posts: 411
- Joined: Thu Apr 06, 2017 3:07 am
- Model of CNC Machine: Camaster Stinger SR24
- Location: Addison, PA
Re: Modeling a Flourish (Freebie Inside)
That is impressive. Well done!
Joe
I have a chip on my shoulder....several more in my hair and lots more all over my shop floor.
I have a chip on my shoulder....several more in my hair and lots more all over my shop floor.
- mtylerfl
- Vectric Archimage
- Posts: 5896
- Joined: Thu Jan 29, 2009 3:54 am
- Model of CNC Machine: -CarveWright CNC -ShopBot Buddy PRSAlpha
- Location: Brunswick, GA
Re: Modeling a Flourish (Freebie Inside)
Looks great, Ted!
Michael Tyler
facebook.com/carvebuddy
-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC
facebook.com/carvebuddy
-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC
- highpockets
- Vectric Wizard
- Posts: 3667
- Joined: Tue Jan 06, 2015 4:04 pm
- Model of CNC Machine: PDJ Pilot Pro
Re: Modeling a Flourish (Freebie Inside)
Great job Ted!
Thanks for sharing the model....
Keep up the good work...
Thanks for sharing the model....
Keep up the good work...
John
Maker of Chips
Maker of Chips