Moulding toolpath problems

This forum is for general discussion about Aspire
Post Reply
lvanduyn
Posts: 33
Joined: Wed Sep 26, 2007 6:28 pm
Location: Alamogordo NM

Moulding toolpath problems

Post by lvanduyn »

I have been playing with the "Catch all tray" project by Todd.
I am having problems with the clearance toolpath rather than the swept toolpath.
The first pic shows the proper cut with 0.0 for machining allowance.
The second and third pics show what happens when 0.03 in machining allowance is added.
Why does the cut go bad when machining allowance is added??
Capture.JPG
Capture2.JPG
Attachments
Capture3.JPG

Post Reply