This forum is for general discussion about Aspire
2 posts • Page 1 of 1
- Vectric Craftsman
- Posts: 107
- Joined: Sun Jul 28, 2013 9:09 pm
- Model of CNC Machine: Shopbot Desktop
Created vectors on a 2 sided drawing. On the 2d side I cut a toolpath on the end of the material, on the 1st side I did a toolpath which was an outer profile without tabs and deleted the excess material. After completing the cuts I wanted to see the end view of both toolcuts cuts. Unfortunately, when I rotated the part the only item I observed was the toolpath for the outer profile not the toolpath on the second side. Anyone have a suggestion of what I did wrong?