Keeping Detail In Small Areas
Keeping Detail In Small Areas
I am cutting letters out of 1” HDU or Signfoam. I need to keep the detail in the tight areas. I have a small radius bit (.078) but I do not want to have to use it to finish the whole piece. Is there another bit or strategy I could use?
- Rcnewcomb
- Vectric Archimage
- Posts: 5928
- Joined: Fri Nov 04, 2005 5:54 am
- Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
- Location: San Jose, California, USA
- Contact:
Re: Keeping Detail In Small Areas
Are you doing V-carving, Pocketing, or 3D toolpaths?
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop
10 fingers in, 10 fingers out, another good day in the shop
Re: Keeping Detail In Small Areas
It would be lettering with a bar across through bottom connecting them all together. It would be completely cut through.