aspire 4.5

This forum is for general discussion about Aspire
Post Reply
4x4laguna
Posts: 2
Joined: Fri Dec 25, 2015 5:55 pm
Model of CNC Machine: 4x4 Laguna

aspire 4.5

Post by 4x4laguna »

I got a job that was made in Aspire 4.5. I have 8.5.
I can not seen to open it. can someone help?

User avatar
Rcnewcomb
Vectric Wizard
Posts: 4242
Joined: Fri Nov 04, 2005 5:54 am
Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
Location: San Jose, California, USA
Contact:

Re: aspire 4.5

Post by Rcnewcomb »

What is the error? You should be able to open earlier version.
- Randall Newcomb
10 fingers in, 10 fingers out
another good day in the shop

User avatar
sylvan356
Vectric Craftsman
Posts: 148
Joined: Thu Dec 12, 2013 5:28 pm
Model of CNC Machine: CAMaster Stinger 1 w/Rotary, Aspire 10
Location: Ormond Beach, Florida

Re: aspire 4.5

Post by sylvan356 »

More likely than not the file you received was created in a pirated copy of 4.5. Legitimate copies of the software will not open them. They can only be opened with the pirated copy!

Savannahdan
Vectric Wizard
Posts: 454
Joined: Sun May 03, 2015 12:25 pm
Model of CNC Machine: Axiom AR8
Location: Savannah, GA

Re: aspire 4.5

Post by Savannahdan »

Another thought could be what I call mismatched toolbases. The 4.5 version file could be looking for a tool you don't have in your 8.5 toolbase. Not sure if that is still an issue since I haven't run into it in quite some time. Also, not sure how you resolved it if that's the issue other than contacting Vectric Support.

Post Reply