Inlay Pocket in Texture Area Tile

This forum is for general discussion about Aspire
Post Reply
chris77
Vectric Apprentice
Posts: 57
Joined: Sun Mar 31, 2019 12:29 pm
Model of CNC Machine: Laguna

Inlay Pocket in Texture Area Tile

Post by chris77 »

Hello,

I have cut a texture area tile into a piece of wood that is .774” thick. The thickness of the texture area tile (model thickness) is .375” with a gap above of 0 and a gap below of.399”. After cutting the texture area tile I wanted to do an inlay pocket in this area. I tried doing a cutting depth of .125” and it did not cut deep enough. I tried a different depth and it went too deep. I am wanting it to cut .125” deep into the texture area tile.

Thanks for your help!

User avatar
TReischl
Vectric Wizard
Posts: 3335
Joined: Thu Jan 18, 2007 6:04 pm
Model of CNC Machine: 8020 Build 48X36X10 RP 2010 Screenset
Location: Leland NC

Re: Inlay Pocket in Texture Area Tile

Post by TReischl »

If you are saying the texture is .375 deep and you want to remove all of it where the inlay pocket goes then you need to set your start depth to .375 and cut depth to .125.

Otherwise you could start at 0 and tell it to cut .5 deep and watch it cut air for a while.
"If you see a good fight, get in it." Dr. Vernon Jones

chris77
Vectric Apprentice
Posts: 57
Joined: Sun Mar 31, 2019 12:29 pm
Model of CNC Machine: Laguna

Re: Inlay Pocket in Texture Area Tile

Post by chris77 »

Thanks for your help!

Post Reply