Cut Sequence

This forum is for general discussion about Aspire
Post Reply
chris77
Vectric Apprentice
Posts: 57
Joined: Sun Mar 31, 2019 12:29 pm
Model of CNC Machine: Laguna

Cut Sequence

Post by chris77 »

I have a series of holes that need to be cut and I would like for them to be cut in a specific order. I cannot find the setting that will let you set the cut sequence. How would I go about doing this? I appreciate the help!

User avatar
Adrian
Vectric Archimage
Posts: 10706
Joined: Thu Nov 23, 2006 2:19 pm
Model of CNC Machine: ShopBot PRS Alpha 96x48
Location: Surrey, UK

Re: Cut Sequence

Post by Adrian »

Depends what toolpath you're using. If you're using the drill or pocket toolpath then you need to select the vectors in the order that you want them cut and check the Use Vector Selection order box on the toolpath.

If it's a profile toolpath then make sure the Show advanced toolpath options at the top of the profile toolpath form is checked and then use one of the options on the Order tab further down the form.

Post Reply