9.5 fails to start

This forum is for general discussion about Aspire
Post Reply
keith20mm
Posts: 22
Joined: Fri Sep 11, 2009 2:01 pm

9.5 fails to start

Post by keith20mm »

Message box

"The procedure entry point GetLogicalProcessorInformation could not be found in the dynamic link library KERNEL32.DLL"

Meanwhile, 8.5 and all others have been running just fine on same machine.

What's the problem?

User avatar
Rcnewcomb
Vectric Archimage
Posts: 5886
Joined: Fri Nov 04, 2005 5:54 am
Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
Location: San Jose, California, USA
Contact:

Re: 9.5 fails to start

Post by Rcnewcomb »

Try reinstalling 9.5
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop

User avatar
BrianM
Vectric Staff
Posts: 1964
Joined: Mon May 16, 2005 10:15 am
Model of CNC Machine: A few ...
Location: Alcester U.K
Contact:

Re: 9.5 fails to start

Post by BrianM »

Are you running XP? This error occurs if service pack 3 isn’t installed. For V9, XP must have service pack 3 (sp3) installed.

Brian

Post Reply