Help with vectorizing a signature

This forum is for general discussion about Aspire
M Queen
Vectric Apprentice
Posts: 84
Joined: Tue Jul 29, 2014 9:25 pm
Model of CNC Machine: WinCNC Hybrid
Location: Buckhannon, WV, USA
Contact:

Re: Help with vectorizing a signature

Post by M Queen »

Not sure of this is what you're looking for but...
Image1.jpg
I vcarved it with a 60° bit. I loaded the image into Paint Shop Pro, sharpened it a little to get the lighter lines to show better, and blurred the image a little to get smoother lines. Then imported it and did a trace. Juggled a few points around and got this.
That's cool. Little Jimmy Dickens was from my state.
Attachments
Signature.crv
(425.5 KiB) Downloaded 46 times
Mike Queen
Microsystems World CNC (WinCNC)
https://www.youtube.com/user/cncMike304

Post Reply