Looking for cribbage board

This forum is for general discussion about Aspire
Post Reply
Bob Reda
Vectric Wizard
Posts: 805
Joined: Wed Aug 16, 2006 7:34 pm
Model of CNC Machine: shopbot 48x48 upgraded prt
Location: Monessen, Pa
Contact:

Looking for cribbage board

Post by Bob Reda »

Some time ago, someone was nice enough to post the crv file for a 3 person oval cribbage board. I thought I had it, apparently it was lost in my black hole. I've searched and cannot find it. if someone would be so kind as to point me in the right direction it would be greatly appreciated.

Thanks
Bob

jimwill2
Vectric Wizard
Posts: 595
Joined: Tue Aug 31, 2010 1:48 am
Model of CNC Machine: CaMaster Stinger w/recoil, FTC
Location: Parkville, Missouri

Re: Looking for cribbage board

Post by jimwill2 »

I think you are referring to Neal. Do a search on the Vectric website and you will find him right away
Jim Williams

dond52
Vectric Craftsman
Posts: 102
Joined: Fri Jan 14, 2011 11:54 pm
Location: Templeton. PA. 16259

Re: Looking for cribbage board

Post by dond52 »

Is this the board you are looking for ?

http://forum.vectric.com/viewtopic.php? ... bage+board

Bob Reda
Vectric Wizard
Posts: 805
Joined: Wed Aug 16, 2006 7:34 pm
Model of CNC Machine: shopbot 48x48 upgraded prt
Location: Monessen, Pa
Contact:

Re: Looking for cribbage board

Post by Bob Reda »

Thanks folks. Yes that is the one, without the deer. He posted the hole pattern much latter. I found that thread.

Bob

Post Reply