Book for Golf Club

This forum is for general discussion about Aspire
Post Reply
Gerry Perrault
Vectric Apprentice
Posts: 73
Joined: Thu Mar 13, 2008 11:04 pm
Location: Granby,Qc, Canada
Contact:

Book for Golf Club

Post by Gerry Perrault »

A golf club who is celebrating their 100th anniversary has commissioned me to fabricate
11 books with all details pertaining details of each course. Details are on the right page
and on the other one is a description of one of the past presidents and founder.
I use HDU 18 pounds 2''. It takes an average of 8 to 10 hours to fabricate one, beside sanding and painting. My wife is very good at painting and of great help,thank you Gisele.
This contract justify the purcase of upgrading to Aspire 4, thank you Vectric.

The small lettering is possible thanks to the v-60 bit from Dimar model 105RR4-60
Attachments
LIVRE COMPLET MINER GOLF REDUIT.jpg
LIVRE GOLF MINER AVANT PEINTURE REDUIT.jpg
I rather be the leader,than the follower

Bob Reda
Vectric Wizard
Posts: 805
Joined: Wed Aug 16, 2006 7:34 pm
Model of CNC Machine: shopbot 48x48 upgraded prt
Location: Monessen, Pa
Contact:

Re: BOOK FOR GOLF CLUB

Post by Bob Reda »

Gerry, that is one fantastic project.

Bob

John Murphy
Vectric Wizard
Posts: 677
Joined: Thu Jan 15, 2009 1:08 am
Model of CNC Machine: AXYZ 5010
Location: Maryhill Ontario Canada
Contact:

Re: BOOK FOR GOLF CLUB

Post by John Murphy »

Very nice! As always, beautiful craftsmanship.

Gerry Perrault
Vectric Apprentice
Posts: 73
Joined: Thu Mar 13, 2008 11:04 pm
Location: Granby,Qc, Canada
Contact:

Re: Book for Golf Club

Post by Gerry Perrault »

first thanks for the people that replied. I finally
finish carving the 11 books i had to do. It took a long
time because some of them had more text then the other
from 10 to 12 hours each just for roughing and finishing.
Yesterday i was able to prime all of them and this morning
the base colour. Now it is up to my wife to fill inthe last colours
then it will be cover with 3 layers of transparent varnish.
I will show you after everything is done what it will look like
allpainted.
I rather be the leader,than the follower

Gerry Perrault
Vectric Apprentice
Posts: 73
Joined: Thu Mar 13, 2008 11:04 pm
Location: Granby,Qc, Canada
Contact:

Re: Book for Golf Club

Post by Gerry Perrault »

sorry here is the picture
Attachments
photo modifié 2.jpg
I rather be the leader,than the follower

BRIANT
Posts: 11
Joined: Tue Feb 04, 2014 9:36 pm
Model of CNC Machine: 40-915x

Re: Book for Golf Club

Post by BRIANT »

Those books you carved were beautiful works of art. What did you carve them out of?

Gerry Perrault
Vectric Apprentice
Posts: 73
Joined: Thu Mar 13, 2008 11:04 pm
Location: Granby,Qc, Canada
Contact:

Re: Book for Golf Club

Post by Gerry Perrault »

Thank you

I have used HDU 2''.
Gerry
I rather be the leader,than the follower

Post Reply