Is it possible to mill past the center point of a log?
Here is aspire job
Here is stl
Thanks!
Aspire Rotary mill past center
- Rcnewcomb
- Vectric Archimage
- Posts: 5886
- Joined: Fri Nov 04, 2005 5:54 am
- Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
- Location: San Jose, California, USA
- Contact:
Re: Aspire Rotary mill past center
No. You would need to adjust the model so there are no areas below the centerline. You may be able to tilt the model enough to deal with it. In this particular case it may be faster and easier to touch up those areas with a chisel.
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop
10 fingers in, 10 fingers out, another good day in the shop