Triquetra Extrude and Weave
- gkas
- Vectric Wizard
- Posts: 1450
- Joined: Sun Jan 01, 2017 3:39 am
- Model of CNC Machine: Aspire, Axiom AR8 Pro+, Axiom 4.2W Laser
- Location: Southern California
Re: Triquetra Extrude and Weave
I'll have to go back and retry the original.... tnx
-
- Vectric Craftsman
- Posts: 110
- Joined: Thu May 06, 2021 3:06 pm
- Model of CNC Machine: CAMaster Stinger 1 SR-24, Shark SD110
Re: Triquetra Extrude and Weave
Gerry,
Steve nailed it.
If you convert the spans at the tip to "lines" and "Bezier" for the other spans, the overlaps disappeared in all my test runs.
Such a subtle difference. It was a good challenge to figure out. Thx
Brooks
Steve nailed it.
If you convert the spans at the tip to "lines" and "Bezier" for the other spans, the overlaps disappeared in all my test runs.
Such a subtle difference. It was a good challenge to figure out. Thx
Brooks
- gkas
- Vectric Wizard
- Posts: 1450
- Joined: Sun Jan 01, 2017 3:39 am
- Model of CNC Machine: Aspire, Axiom AR8 Pro+, Axiom 4.2W Laser
- Location: Southern California
Re: Triquetra Extrude and Weave
I will definitely try this. Right now I'm on the road visiting friends.
tnx,
Gerry
tnx,
Gerry