Triquetra Extrude and Weave

This forum is for general discussion about Aspire
User avatar
gkas
Vectric Wizard
Posts: 1450
Joined: Sun Jan 01, 2017 3:39 am
Model of CNC Machine: Aspire, Axiom AR8 Pro+, Axiom 4.2W Laser
Location: Southern California

Re: Triquetra Extrude and Weave

Post by gkas »

I'll have to go back and retry the original.... tnx

BrooksM
Vectric Craftsman
Posts: 110
Joined: Thu May 06, 2021 3:06 pm
Model of CNC Machine: CAMaster Stinger 1 SR-24, Shark SD110

Re: Triquetra Extrude and Weave

Post by BrooksM »

Gerry,

Steve nailed it.
If you convert the spans at the tip to "lines" and "Bezier" for the other spans, the overlaps disappeared in all my test runs.
Such a subtle difference. It was a good challenge to figure out. Thx

Brooks
Attachments
Trifoil Tip Line Segments - Bezier other spans.PNG

User avatar
gkas
Vectric Wizard
Posts: 1450
Joined: Sun Jan 01, 2017 3:39 am
Model of CNC Machine: Aspire, Axiom AR8 Pro+, Axiom 4.2W Laser
Location: Southern California

Re: Triquetra Extrude and Weave

Post by gkas »

I will definitely try this. Right now I'm on the road visiting friends.

tnx,
Gerry

Post Reply