What is this showing
-
- Vectric Wizard
- Posts: 722
- Joined: Sun Jun 16, 2013 4:40 am
- Model of CNC Machine: Home Built 4-axis Router
- Location: Fort Collins, CO
Re: What is this showing
I had that on a file and Vectric acknowledged something to be fixed. I have not gone back to check if they did in newer versions.
But it showed only, when turning a 2-sided preview with the mouse looking at the back of the active side and vanished when zooming in. So, for me it was not a big deal. Just swap the active side to look at the back and it does not show.
But it showed only, when turning a 2-sided preview with the mouse looking at the back of the active side and vanished when zooming in. So, for me it was not a big deal. Just swap the active side to look at the back and it does not show.
Dovetail and Finger Joint, Puzzle, Maze and Guilloche freeware at fabrikisto.com/tailmaker-software
- Tex_Lawrence
- Vectric Wizard
- Posts: 957
- Joined: Fri Mar 25, 2016 11:30 am
- Model of CNC Machine: Shapeoko3XXL; JTech7W; V-CarvePro 12.004
- Location: Dayton, Texas (Don't Mess With My Texas!)
Re: What is this showing
That could be called an “easter egg” in programming circles; something a silly programmer adds without permission and only shows up during certain situations.
Vectric would probably be reluctant to admit such a thing, and they might have some trouble locating it.
Vectric would probably be reluctant to admit such a thing, and they might have some trouble locating it.
Tex — Crooked Wood Products
Now there's a man with an open mind – you can feel the breeze from here.
Now there's a man with an open mind – you can feel the breeze from here.
- adze_cnc
- Vectric Wizard
- Posts: 4373
- Joined: Sat Jul 27, 2013 10:08 pm
- Model of CNC Machine: AXYZ 4008
- Location: Vancouver, BC, Canada
Re: What is this showing
In the options try changing to the software renderer and see if it goes away.