Slop for model jeep tire

[JMOlshefski]

I do not know how to insert picture to file, so I attached it

[sharkcutup]

Something Like This???

Sharkcutup

[adze_cnc]

Yeah. It’s really unclear what you are looking for. It took me a bit to figure out is was a “slope”. There were also many 1/8-s didn’t add up.

If your slope is going to be as you’ve started with the moulding toolpath then you are going to need to create 30 toolpaths. I stopped after 4:
 

 
If what you are looking for is a pseudo beveled pinion gear then you are going to use the “Fluting Toolpath” as I did here:
 

 
I just selected the 30 radial lines and used the following parameters:
 

[sharkcutup]

Could end up like this!! It all up to the users imagination!!

Sharkcutup

[JMOlshefski]

Exactly what I was looking for, I still not always clear on the fluting verses molding verses chamfer tool.

Thanks
JOe

"I just selected the 30 radial lines and used the following parameters:"