File Size

This forum is for general discussion regarding VCarve Pro
User avatar
adze_cnc
Vectric Wizard
Posts: 4325
Joined: Sat Jul 27, 2013 10:08 pm
Model of CNC Machine: AXYZ 4008
Location: Vancouver, BC, Canada

Re: File Size

Post by adze_cnc »

If the file is too large then just images of the settings will do. See my previous posts for what's needed.

harpone
Posts: 10
Joined: Fri Nov 05, 2021 10:25 pm
Model of CNC Machine: nextwave sd100

Re: File Size

Post by harpone »

I went back to the original .jpeg image, imported it as a bitmap and ended up with a .tap file which I engraved on a scrap piece of plywood. The cutting time on my small NextWave CNC was less than 30 minutes. Nice engraving job. The unrelated cuts on the plywood were from a previous project attempt.

Thanks to all for your input.
Attachments
IMG_1707.jpeg

Post Reply