I volunteer at a non-profit and will be training students in VCarve Desktop.
All students would be in the same building as the CNC machine (Shark 510).
We have 10 laptops at our disposal.
Is VCarve Pro Maker Space Edition the only option for training multiple people on multiple laptops?
Are there other ways to accomplish this training at reasonable cost?
Does anyone have experience and advice on using the MakerSpace edition?
MakerSpace edition
- FabLab Wageningen
- Vectric Craftsman
- Posts: 214
- Joined: Mon May 09, 2022 8:17 pm
- Model of CNC Machine: Ooznest Workbee 1500x1500
- Location: Wageningen, Netherlands
- Contact:
Re: MakerSpace edition
We (FabLab = Makerspace) have installed the 'Makerspace Edition' last year.
The software works excellent. But we will only start member training next Spring / Summer, as we first have to train the trainers. None of us had CNC experience (only laser). Support from Vectric so far was good, this forum rocks.
Marcel.
The software works excellent. But we will only start member training next Spring / Summer, as we first have to train the trainers. None of us had CNC experience (only laser). Support from Vectric so far was good, this forum rocks.
Marcel.
-
- Posts: 1
- Joined: Sat Dec 10, 2022 4:39 pm
- Model of CNC Machine: ooznest workbee
Re: MakerSpace edition
setup your laptops as "clients". The software works exactly the same but does not allow saving of toolpaths to g-code. You can have an unlimited number of "clients" but only 5 "master" copies which must be at your makerspace.