Vcarve desktop help

[coleboyb]

Hi, I'm new to using Vcarve desktop and using vectors and I am creating a crib board and somehow have a vector that I cannot delete. It is the circle in the middle with the line through it. I can select everything else and modify everything else but not that one. In my 3D model it shows as having a drill hole in the middle of the line. Any help or suggestions would greatly be appreciated so I know what I am doing wrong. Thanks -Mike

[martin54]

Don't think that is actually a vector but the actual toolpath, there may have been a vector there when you created the original toolpath, try recalculating the toolpath for the holes & see if that makes a difference

[sharkcutup]

Also check your layers to make sure there are no vectors located there at the location of your concern. Any layers which are on "Light Bulb On"

Sharkcutup

[coleboyb]

thanks for your help! I went in and selected the groups that were for drilling the holes and ungrouped them and deleted the line that was on top of the hole and it disappeared . Thanks everyone