post processor for Axiom
-
- Vectric Craftsman
- Posts: 148
- Joined: Sun Jul 24, 2016 5:40 pm
- Model of CNC Machine: Axiom AR4 V5 Pro
- Location: Colorado
post processor for Axiom
What post processor is used for the Axiom Basic series?? It is not listed
- martin54
- Vectric Archimage
- Posts: 7339
- Joined: Fri Nov 09, 2012 2:12 pm
- Model of CNC Machine: Gerber 48, Triac PC, Isel fixed gantry
- Location: Kirkcaldy, Scotland
Re: post processor for Axiom
When you say it's not listed do you mean the machine isn't listed when you run the kickstarter? If that is the case then is the post processor you were using previously listed in the post processor list? Do you know what controller it uses as that may help.
If you don't get a reply then probably best to send Axiom a message as they will probably be able to tell you
Or you might get an answer here:
https://axiomprecision.proboards.com/
If you don't get a reply then probably best to send Axiom a message as they will probably be able to tell you
Or you might get an answer here:
https://axiomprecision.proboards.com/
-
- Vectric Craftsman
- Posts: 216
- Joined: Tue Jun 12, 2018 3:07 pm
- Model of CNC Machine: Axiom AR 8 Pro+
- Location: Cambria, CA
Re: post processor for Axiom
My advice is call Axiom and ask for Chad McCarty.