post processor for Axiom

This forum is for general discussion regarding VCarve Pro
Post Reply
zaxis
Vectric Craftsman
Posts: 148
Joined: Sun Jul 24, 2016 5:40 pm
Model of CNC Machine: Axiom AR4 V5 Pro
Location: Colorado

post processor for Axiom

Post by zaxis »

What post processor is used for the Axiom Basic series?? It is not listed

User avatar
martin54
Vectric Archimage
Posts: 7332
Joined: Fri Nov 09, 2012 2:12 pm
Model of CNC Machine: Gerber 48, Triac PC, Isel fixed gantry
Location: Kirkcaldy, Scotland

Re: post processor for Axiom

Post by martin54 »

When you say it's not listed do you mean the machine isn't listed when you run the kickstarter? If that is the case then is the post processor you were using previously listed in the post processor list? Do you know what controller it uses as that may help.
If you don't get a reply then probably best to send Axiom a message as they will probably be able to tell you :lol: :lol:

Or you might get an answer here:

https://axiomprecision.proboards.com/

laflippin
Vectric Craftsman
Posts: 216
Joined: Tue Jun 12, 2018 3:07 pm
Model of CNC Machine: Axiom AR 8 Pro+
Location: Cambria, CA

Re: post processor for Axiom

Post by laflippin »

My advice is call Axiom and ask for Chad McCarty.

Post Reply