Spoil-board help
Spoil-board help
I’m having a bit of trouble finding any tutorial on spoil-board surfacing or engraving a grid on my spoil-board, after surfacing. Any help will be greatly appreciated. My table is 12”X 13” and I have an Next Wave Shark SD100, if that is important.
- adze_cnc
- Vectric Wizard
- Posts: 4380
- Joined: Sat Jul 27, 2013 10:08 pm
- Model of CNC Machine: AXYZ 4008
- Location: Vancouver, BC, Canada
Re: Spoil-board help
Possible duplicate post (different words; same general question):viewtopic.php?f=2&t=37658&sid=6edf706dc ... c3be27e525
Re: Spoil-board help
All I do is a .5mm pocket cut across the entire surface of the spoil board with a 20mm bit, then I create a 50x50mm grid across the entire board and cut that to a depth of 1mm with a 90 V bit. This may work for you.
- IslaWW
- Vectric Wizard
- Posts: 1403
- Joined: Wed Nov 21, 2007 11:42 pm
- Model of CNC Machine: CNC Controller Upgrades
- Location: Bergland, MI, USA
Re: Spoil-board help
This one from a few years back may help you:
Gary Campbell
GCnC Control
ATC & Servo Controller Controller Upgrades
GCnC411 (at) gmail.com
GCnC Control
ATC & Servo Controller Controller Upgrades
GCnC411 (at) gmail.com