Looking for font
- Makingtoothpicks
- Vectric Wizard
- Posts: 520
- Joined: Tue Jul 23, 2013 8:46 pm
- Model of CNC Machine: Cncrouterparts CPR2448
- Location: Burien, Wa
- Contact:
Looking for font
There is a font on Letter Head fonts I would like to use for a job. $45 is to much for a 1 time use. The font is called Chromeliner http://www.letterheadfonts.com/fonts/chromeliner.php Anyone know of a similar font that is free or low cost.I have checked some of the font sites but nothing I see looks good.
Re: Looking for font
This one looks somewhat close...?
Dymaxion Script à € by Nick's Fonts
https://www.dafont.com/dymaxion-script.font
Dymaxion Script à € by Nick's Fonts
https://www.dafont.com/dymaxion-script.font
- martin54
- Vectric Archimage
- Posts: 7339
- Joined: Fri Nov 09, 2012 2:12 pm
- Model of CNC Machine: Gerber 48, Triac PC, Isel fixed gantry
- Location: Kirkcaldy, Scotland
Re: Looking for font
If you save the image from the letterheads site you can then use that image to search for one similar on the free font sites most of them have a section where you can upload an image & then they try to match it. Results are often way off but worth a try you may get lucky.
- Makingtoothpicks
- Vectric Wizard
- Posts: 520
- Joined: Tue Jul 23, 2013 8:46 pm
- Model of CNC Machine: Cncrouterparts CPR2448
- Location: Burien, Wa
- Contact:
Re: Looking for font
Thank you for the replies.
Dymaxion was close but not right.
Martin I will try that.
Don
Dymaxion was close but not right.
Martin I will try that.
Don