Looking for font

This forum is for general discussion regarding VCarve Pro
Post Reply
User avatar
Makingtoothpicks
Vectric Apprentice
Posts: 512
Joined: Tue Jul 23, 2013 8:46 pm
Model of CNC Machine: Cncrouterparts CPR2448
Location: Burien, Wa
Contact:

Looking for font

Post by Makingtoothpicks »

There is a font on Letter Head fonts I would like to use for a job. $45 is to much for a 1 time use. The font is called Chromeliner http://www.letterheadfonts.com/fonts/chromeliner.php Anyone know of a similar font that is free or low cost.I have checked some of the font sites but nothing I see looks good.

hooby
Posts: 20
Joined: Tue Nov 05, 2019 4:51 pm
Model of CNC Machine: Shapeoko3

Re: Looking for font

Post by hooby »

This one looks somewhat close...?
Dymaxion Script à € by Nick's Fonts

https://www.dafont.com/dymaxion-script.font

User avatar
martin54
Vectric Wizard
Posts: 5111
Joined: Fri Nov 09, 2012 2:12 pm
Model of CNC Machine: Gerber System 48,Denford Triac Modified
Location: Crossgates, Scotland

Re: Looking for font

Post by martin54 »

If you save the image from the letterheads site you can then use that image to search for one similar on the free font sites most of them have a section where you can upload an image & then they try to match it. Results are often way off but worth a try you may get lucky.

User avatar
Makingtoothpicks
Vectric Apprentice
Posts: 512
Joined: Tue Jul 23, 2013 8:46 pm
Model of CNC Machine: Cncrouterparts CPR2448
Location: Burien, Wa
Contact:

Re: Looking for font

Post by Makingtoothpicks »

Thank you for the replies.
Dymaxion was close but not right.
Martin I will try that.

Don

Post Reply