International Cheese Board

[Aussie]

Hi Guys,
I was just checking the toolpaths and I have a question, the V Carve toolpath has a start depth of 0.0 and no flat depth, how does the V Bit know how deep to cut?
Am I having a "seniors" moment?

Thanks
Ron

[Aussie]

Yes I was having a seniors moment please disregard

[scottp55]

Gee Ron.....Never happens to Me

[rtibbs]

Been there, done that.

Been there, done that

Oops just done that

[Aussie]

you guys have a wicked sense of humor

[TReischl]

Has your question been answered?

Did a little voice whisper in your ear?

Was it an epiphany of sorts?

Is this the vectric forum?

[Aussie]

Has your question been answered?

Did a little voice whisper in your ear?

Was it an epiphany of sorts?

Is this the vectric forum?

I gave myself a good slapping.... that did the trick

[lsvien]

All I could think about it was a discussion about some international organization that regulates cheese. What in the heck did that have to do with Vectric software?

[sharkcutup]

Nah, ya might say that this thread is for expressing one's self on the lighter side of life!

Sharkcutup