carving depth

This forum is for general discussion regarding VCarve Pro
Post Reply
Posts: 2
Joined: Mon Apr 15, 2019 5:32 am
Model of CNC Machine: Stylecnc Stj1390

carving depth

Post by Ron57 »

I had a model that was divided into 3 so each slice was 27mm on the Z, but the machine cut to 32mm deep. Any suggestions as to what may cause this or what I have over looked


Re: carving depth

Post by ezurick »

Without details of your setup and perhaps an upload of the vcarve file, most would have no clue how to help.

Is your Z setup to the top of the material and is it truly zero'd? Are you using the proper post-processor or your machine?

Post Reply