Post Processor

This forum is for general discussion regarding VCarve Pro
Post Reply
naijin
Vectric Apprentice
Posts: 90
Joined: Wed Dec 18, 2013 10:25 am
Model of CNC Machine: home made

Post Processor

Post by naijin »

Hi there, I used to use the MACH2/3 Arcs(mm)(.txt) when I was using Mac3, but I am now using UCCNC software, so which post processor do I save my tool paths now? I have a home made router no brand names etc.

Nick :?:

User avatar
IslaWW
Vectric Wizard
Posts: 1308
Joined: Wed Nov 21, 2007 11:42 pm
Model of CNC Machine: The Ultimate Woodworking Machine
Location: Marquette, MI, USA

Re: Post Processor

Post by IslaWW »

Nick...
You can use the same one
Gary Campbell
GCnC Control
ATC & Servo Controller Controller Upgrades
GCnC411 (at) gmail.com

User avatar
Makingtoothpicks
Vectric Apprentice
Posts: 512
Joined: Tue Jul 23, 2013 8:46 pm
Model of CNC Machine: Cncrouterparts CPR2448
Location: Burien, Wa
Contact:

Re: Post Processor

Post by Makingtoothpicks »

I use UCCNC also and I use the Mach3 inch atc PP. It works just fine.

Don

naijin
Vectric Apprentice
Posts: 90
Joined: Wed Dec 18, 2013 10:25 am
Model of CNC Machine: home made

Re: Post Processor

Post by naijin »

Thanks for the replies, will still use Mach2/3 pp than.

Nick

User avatar
martin54
Vectric Wizard
Posts: 5260
Joined: Fri Nov 09, 2012 2:12 pm
Model of CNC Machine: Gerber System 48,Denford Triac Modified
Location: Crossgates, Scotland

Re: Post Processor

Post by martin54 »

There is also a pp for UCCNC listed if you have a look in the pp list :lol: :lol:

Post Reply