New Drag Knife

[martin54]

Think it is pre installed Mark, open the software & check in the gadgets drop down

[CosmosK]

Since some people are asking for it and after some thought, I'm going to expand the design to add a couple offsets.

I’m going to offer the following models:
1.5mm offset, 1/4" shank (new)
3.0mm offset, 1/4" or 3/8” shank (current)
4.5mm offset, 3/8” shank (new)

I’m going to reschedule some stuff and try to have these ready by the first week of January. Send me an email (info@cosmos-industrial.com) if you're interested and I'll throw in a Holiday coupon code for a discount.

[Mark Bolton]

Think it is pre installed Mark, open the software & check in the gadgets drop down

Well isnt that just ridiculous . I looked everywhere but the most obvious. Im not sure I should be playing with sharp things. Thanks

[bwohn65]

How did you stop the motor rotation with with Vectric or Aspire? I don't see that anywhere to stop the spindle? Thx!

[AlanAndrews]

website says that this item has been discontinued?

but no replacement part is available on the website.

what went wrong with it? ....I've been thinking about investing in a drag knife for a little while.

does anyone have any recommendations please?

[Mark]

Hello bwohn65,

How did you stop the motor rotation with with Vectric or Aspire? I don't see that anywhere to stop the spindle? Thx!

Usually you would need to edit a custom post processor to remove any instructions in the header of the post processor
that start the spindle.

Cheers,

Mark.

[CosmosK]

I discontinued the product as I got busy with other stuff and it's fairly difficult to make. There should be a couple other options out there. Thanks

[slowdigits]

What is the max cut depth of this? is it only restricted by blade offset
Steve

[CosmosK]

Yes, it is the same as the blade offset. I'm working on bringing these back online. I will update when they are back in stock. Thanks

[CosmosK]

Back in stock after 2.5 years!

The new model features a 7075 AL body (previously 6061). This is good for durability and thread strength. It is gray anodized as well.

Three models to choose from.

https://cosmos-industrial.com/index.php ... ex&cPath=4




Thanks!

[ChrisInEstes]

Good to know!

Chris

[CosmosK]

Got a new one out:

Adjustable Offset Drag Knife



Adjustable Offset: 2-12mm (~1/16 - 1/2”)
Blades: Any standard sized utility blade. This lets you use HSS, Tin coated or Carbide edged blades.
Set screw is used to recall offset position between blade changes.
Body: Gray anodized 7075 Aluminum (high strength). 62.3mm long (not including blade stick out)
Bearings: Dual 7/8” diameter ball bearings offer best balance between radial load capacity and minimal overall length
Shank: Hardened steel 3/8”. 36.2mm length.
Clamp: 303 stainless steel. M5 bolt

Made in Fort Worth, TX
Days to ship: 1-2 (usually same day)