Can I copy my registered copy of VcarvePro to my laptop?
It is only installed on one desktop.
Thanks
Mr. Chips
Copy Registered copy of VcarvePro to laptop
- Adrian
- Vectric Archimage
- Posts: 14690
- Joined: Thu Nov 23, 2006 2:19 pm
- Model of CNC Machine: ShopBot PRS Alpha 96x48
- Location: Surrey, UK
Re: Copy Registered copy of VcarvePro to laptop
You can install VCarve on up to 3 computers as long as you are the only person who uses them.
http://support.vectric.com/aspire-quest ... stalled-on
http://support.vectric.com/aspire-quest ... stalled-on
-
- Vectric Craftsman
- Posts: 235
- Joined: Wed Sep 17, 2008 2:28 pm
- Model of CNC Machine: MAKE DO
- Location: GILBERT AZ
Re: Copy Registered copy of VcarvePro to laptop
That's good news, now how do I go about doing that. I do seem to remember that it was a complete download, no CD's involved. And even if there was a CD we have just moved two weeks ago and finding that CD would be an impossible task.
I have used Vcarvepro for for many years and am 76 years old so please use a very bold and dark crayon to describe this procedure, and please don't leave anything out of the instructions that you figure "everyone knows that".
Thanks
Mr. Chips
I have used Vcarvepro for for many years and am 76 years old so please use a very bold and dark crayon to describe this procedure, and please don't leave anything out of the instructions that you figure "everyone knows that".
Thanks
Mr. Chips
-
- Vectric Wizard
- Posts: 1592
- Joined: Sun Sep 16, 2007 2:59 pm
- Model of CNC Machine: Custom DIY
- Location: Lake St Clair, MI, USA
- Contact:
Re: Copy Registered copy of VcarvePro to laptop
From Vectric.com, go to Support > Customer Portal, and log in.
You can download your software and get your license info there as well.
You can download your software and get your license info there as well.
Gerry - http://www.thecncwoodworker.com
-
- Posts: 9
- Joined: Sun Feb 28, 2016 10:29 pm
- Model of CNC Machine: Probotix Meteor
- Location: Edwardsville, KS 66111
Re: Copy Registered copy of VcarvePro to laptop
If the 3 copies are in use, computer in shop, one at home, laptop ...and one of those computers is replaced, can I transfer from the replaced unit to a new one?
- Rcnewcomb
- Vectric Archimage
- Posts: 5935
- Joined: Fri Nov 04, 2005 5:54 am
- Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
- Location: San Jose, California, USA
- Contact:
Re: Copy Registered copy of VcarvePro to laptop
Yes, as long as it is on no more than 3 computers at a time and is used by only one person.I transfer from the replaced unit to a new one?
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop
10 fingers in, 10 fingers out, another good day in the shop