Help with urn box top
Help with urn box top
Looking for a 3D image, basically a simple curve profile for an urn box top for my recently passed father. The top will be 10" x 8", start out with a 2" thick lid which crowns in the center, tapers down to around 1/2" @ the ends. I found the domes in the included clipart, but nothing rectangular, only round. Nothing in the Vectric site models either. Any suggestions?
-
- Vectric Craftsman
- Posts: 123
- Joined: Thu Nov 01, 2012 2:05 am
- Model of CNC Machine: Camaster Panther 4x8
Re: Help with urn box top
You don't have Aspire, right?
-
- Vectric Craftsman
- Posts: 123
- Joined: Thu Nov 01, 2012 2:05 am
- Model of CNC Machine: Camaster Panther 4x8
Re: Help with urn box top
Something like this? I have spent very little time with Aspire so not sure if this will work right or not...
Hmmm. Didn't attach. I'll try again.
Hmmm. Didn't attach. I'll try again.
-
- Vectric Craftsman
- Posts: 123
- Joined: Thu Nov 01, 2012 2:05 am
- Model of CNC Machine: Camaster Panther 4x8
Re: Help with urn box top
Ok. It loads but when it gets to 100% it disappears. What am I doing wrong? Pic works but not the crv3d or the zip...
Re: Help with urn box top
Thats it exactly, don't have aspire-yet
Re: Help with urn box top
Thanks again David! Here is the finished urn box top with (well, not completely finished)