Diamond Drag Bit
-
- Vectric Craftsman
- Posts: 102
- Joined: Tue Oct 18, 2011 1:31 am
- Model of CNC Machine: FLA100-00
- Location: Hemet,CA.
Diamond Drag Bit
Does anyone know where I could purchase a good diamond drag bit that would fit my Hitachi M12? I was looking at one on Amazon but some of the user on CNC face book said they got bad ones.
Lou
-
- Vectric Craftsman
- Posts: 298
- Joined: Thu Aug 21, 2014 8:13 pm
- Model of CNC Machine: ULS M300, Rockler 60th Ann. Shark
- Location: Dallas, TX USA
- Contact:
Re: Diamond Drag Bit
I believe your router is a 1/2" collet so you can check either at widget works or shopbot. They are $179
there are others on ebay as well.
there are others on ebay as well.
"Out of my mind. Back in 5 Minutes."
-
- Vectric Craftsman
- Posts: 182
- Joined: Sat Jun 30, 2012 1:41 am
- Model of CNC Machine: CAMaster Stinger II
- Location: Wisconsin
Re: Diamond Drag Bit
I use one from here, http://www.usroutertools.com
Charlie
Aspire, CAMaster Stinger II
Aspire, CAMaster Stinger II
- Xxray
- Vectric Wizard
- Posts: 2304
- Joined: Thu Feb 17, 2011 8:47 am
- Model of CNC Machine: CAMaster Stinger 1
- Location: MI USA
Re: Diamond Drag Bit
Save your $$ and get the ebay one would be my advice, virtually no difference if any.
Doug
-
- Vectric Craftsman
- Posts: 102
- Joined: Tue Oct 18, 2011 1:31 am
- Model of CNC Machine: FLA100-00
- Location: Hemet,CA.
Re: Diamond Drag Bit
Xxray thanks that sounds like a winner what degree for the diamond point do most use for acrylic and brass?
Lou
- Xxray
- Vectric Wizard
- Posts: 2304
- Joined: Thu Feb 17, 2011 8:47 am
- Model of CNC Machine: CAMaster Stinger 1
- Location: MI USA
Re: Diamond Drag Bit
I never paid attention to degree and not sure what if any options there are, have been using it successfully for years
Doug