wider path with a profile operation

This forum is for general discussion regarding VCarve Pro
Post Reply
labautoman
Vectric Apprentice
Posts: 9
Joined: Thu Jul 15, 2010 11:02 pm

wider path with a profile operation

Post by labautoman »

Hi,
Is there an easy way to make 3/8 wide profile cut with 1/4 bit that is 3/4 deep and go 1/8 per pass and have it do both pass before it goes to the next depth? By using the allowance offset I can get it to do but it will cut all the down before it shifts over unless I do individual passes for each time around.

Thanks

dond52
Vectric Craftsman
Posts: 102
Joined: Fri Jan 14, 2011 11:54 pm
Location: Templeton. PA. 16259

Re: wider path with a profile operation

Post by dond52 »

You could offset the profile by 3/8 and then pocket what is between them.

Post Reply