simulation

[DiverseGraphx]

I am a complete beginner with vcarve pro, I do have other laser software for laser, the two programs have some similarities. However when putting in a pocket tool path for the attached photo sample and running the simulation its showing imcomplete job runs. Example in the attached photo the outer ring is showing the carve did not complete. Any help is appreciated.

[Rcnewcomb]

Can you post the CRV file? That will eliminate a lot of guessing.

To upload a file/photo:

• Click on the Upload attachment button below the message area
• Click on Choose File and select your file
• Finally, click on Add the file to upload it to the forum

If the file is too large to upload here you can use a file sharing site such as drive.google.com, onedrive.com, or dropbox.com. They all have free accounts available

• Upload the file to the file sharing site
• Make the link shareable
• Share the link to the file here

[adze_cnc]

Why the toolpath is not going into the upper right quarter is that it can't fit between the two rings.

If you look at the two outer rings you will see that the distance between the two rings on the left side is grater than on the right side. If you centre the two rings with respect to each other it should work.