Laser Post Processor Required

Post general information and questions relating to Cut2D in this Forum.
Post Reply
Advall
Posts: 7
Joined: Tue Feb 16, 2010 12:42 am

Laser Post Processor Required

Post by Advall »

I am looking for a Laser post processor for Cut 2D

I am running a generic laser cutter running a Smoother ware board interface and using the LaserWeb interpreter,


Any assistance is much appreciated

Regards Advall

BDM
Vectric Craftsman
Posts: 167
Joined: Tue Jan 04, 2011 3:52 pm
Location: S.E. Michigan

Re: Laser Post Processor Required

Post by BDM »

I would start here: https://jtechphotonics.com/?p=19034

I'm guessing your system is GRBL based?

Advall
Posts: 7
Joined: Tue Feb 16, 2010 12:42 am

Re: Laser Post Processor Required

Post by Advall »

Regret no. I am used the latest Smoothie Ware firmware.

BDM
Vectric Craftsman
Posts: 167
Joined: Tue Jan 04, 2011 3:52 pm
Location: S.E. Michigan

Re: Laser Post Processor Required

Post by BDM »


Post Reply