adding a curve to a circle
Posted: Thu Jun 17, 2021 4:30 am
Anyone had this problem, I am trying to make a pocket for a spanner tray, most of the time all goes well, I create a circle and two lines for the handle, the lines are stopped just short of the circle and then I want to create a curve from the line to the circle, both the line and the circle have a guide line where I want to connect both, making a web between them.
As I said most if the time all goes well but sometimes I cannot get the line for the web to connect to the circle unless I focus in to the max, which is a bit of a pain.
I've tried restarting the program, rebooting the computer, even rebooting the wife ( that doesn't work either and the food tastes a bit strange for a while) posting.php?mode=post&f=18#
Any suggestions
John
As I said most if the time all goes well but sometimes I cannot get the line for the web to connect to the circle unless I focus in to the max, which is a bit of a pain.
I've tried restarting the program, rebooting the computer, even rebooting the wife ( that doesn't work either and the food tastes a bit strange for a while) posting.php?mode=post&f=18#
Any suggestions
John