New to CNC- Looking for best fonts and Bits
-
- Posts: 1
- Joined: Fri Jan 08, 2021 12:55 am
- Model of CNC Machine: Legacy 3x5 Gen 2
- Location: St. Leonard, MD
New to CNC- Looking for best fonts and Bits
I'm new to CNC operation. Just received machine and been busy making sawdust. I'm trying to figure out which font to use and which bit to use to carve or engrave small letters, i.e. 1/8' or so high. Does anyone know what works best or looks good?
- Adrian
- Vectric Archimage
- Posts: 14684
- Joined: Thu Nov 23, 2006 2:19 pm
- Model of CNC Machine: ShopBot PRS Alpha 96x48
- Location: Surrey, UK
Re: New to CNC- Looking for best fonts and Bits
For very small letters like that you're nearly always going to be looking at the Single Line fonts (it's a choice in the Text Tool) and a profile toolpath set to be on the vector with a very fine tool like a 30 or 45 degree engraving bit. I do a lot of lettering that size for race car panels and that works for me.
Laser is probably best for that job but I just haven't had the time to get mine setup and working yet.
Laser is probably best for that job but I just haven't had the time to get mine setup and working yet.
- TReischl
- Vectric Wizard
- Posts: 4657
- Joined: Thu Jan 18, 2007 6:04 pm
- Model of CNC Machine: 8020 48X36X7 RP 2022 UCCNC Screenset
- Location: Leland NC
Re: New to CNC- Looking for best fonts and Bits
What looks best is in the eye of the beholder. Some folks love fonts like Comic Sans. Me? Not so much.
If you are carving positive letters, the thickness of the strokes and things like serifs can become an issue depending on the size you are cutting. Things like that are learned through experience. There are no hard and fast rules. So have fun and experiment!
Oh, one other thing, small fonts get lost on grainy woods like oak unless you fill them in with something. Even then they can get lost.
"If you see a good fight, get in it." Dr. Vernon Johns
- adze_cnc
- Vectric Wizard
- Posts: 4380
- Joined: Sat Jul 27, 2013 10:08 pm
- Model of CNC Machine: AXYZ 4008
- Location: Vancouver, BC, Canada
Re: New to CNC- Looking for best fonts and Bits
One of my Favourite quotes about MS Comic Sans goes something like:
from Vincent Connare the designer of MS Comic Sans...If you love it, you don't know much about typography. And if you hate it, you really don't know much about typography either and you should get another hobby.