Image reversed in my design
-
- Posts: 21
- Joined: Wed Jan 13, 2021 6:48 pm
- Model of CNC Machine: Genmitsu CNC 3018-PRO
- Location: Prince george BC, Ca
Image reversed in my design
Crib War project. Tried engraving my lines. Worked. Except for a slight problem. The image is reversed from left to right. What I did to accomplish that I don't know. This is the image in Cut2D. I generated the tool path for the lines and it came out reversed. I've read up on it and can't find anything to suggest what I may have done. I can't get it back to what it should look like. Not to worry. I had older saved an older image of what it should be; so all is good. Just would like to know what I did or didn't do to cause this!
- Rcnewcomb
- Vectric Archimage
- Posts: 5886
- Joined: Fri Nov 04, 2005 5:54 am
- Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
- Location: San Jose, California, USA
- Contact:
Re: Image reversed in my design
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop
10 fingers in, 10 fingers out, another good day in the shop