saving image

Post general information and questions relating to Cut2D in this Forum.
Post Reply
David Tolley
Posts: 25
Joined: Wed Nov 29, 2017 9:05 pm
Model of CNC Machine: workbee

saving image

Post by David Tolley »

Hi All todays question as follows:

once a design has been completed along with tool paths, how can I save the 3D image of the completed project 3D to send to a client?

Many Thanks

Dave

MarkJohnston
Vectric Wizard
Posts: 815
Joined: Tue Jun 01, 2010 4:51 pm
Model of CNC Machine: CAMaster MC4848
Location: Prescott AZ

Re: saving image

Post by MarkJohnston »

After you run the final preview for the toolpaths you will see the completed image.
Select the "save preview image" and you can save it as a jpg file to a place on your disk.
You can then attach it to an email and send it to your client.

Mark

David Tolley
Posts: 25
Joined: Wed Nov 29, 2017 9:05 pm
Model of CNC Machine: workbee

Re: saving image

Post by David Tolley »

Thanks Mark

Post Reply