Just like the title says I would like to get into edge lit acrylic and have a few good ideas that I would like to try.
Is there a good thread on doing this type of work start to finish with tooling recommendations? I am ready to buy a few bits for this but I know nothing about the edge lit procedures etc.
Second is I started routing aluminum with pretty good results making some small emblems etc. I have a few problems with this so far.
I am using 1/8" aluminum routing with 1/8" bit It is a straight spiral flute bit so I cant get nice rounded edges etc. Any better ways to do this without having to upgrade software to something with a tool change?
I have seen some highly detailed emblems and that's what I would like to start making.
Thanks for any help.
Lots of questions inside! edge lit and routing aluminum
-
- Posts: 11
- Joined: Thu Jan 15, 2015 2:39 am
- Model of CNC Machine: 5x9 diy cnc router
- Xxray
- Vectric Wizard
- Posts: 2304
- Joined: Thu Feb 17, 2011 8:47 am
- Model of CNC Machine: CAMaster Stinger 1
- Location: MI USA
Re: Lots of questions inside! edge lit and routing aluminum
Here is a pretty comprehensive thread about edge lit, no doubt quite a few others as well
http://forum.vectric.com/viewtopic.php?t=17065
http://forum.vectric.com/viewtopic.php?t=17065
Doug