A couple more Vcarve projects

[scotttarnor]

2 of my latest projects

[scottp55]

Merry Christmas Scott!
That couple came out Great!!
(even with the weird marks you had:)
Is that black paint that covered the marks so well?
Be Well!
scott

[scotttarnor]

Merry Christmas Scott! The paint is just black acrylic it is what I have been using on all my photos lately, I have better luck with it than gel stain. I started sanding all the unexpected lines out but then decided to leave some of them. I thought the texture might look good in the large black areas.
No requested work this weekend so I am hope to get back on the bear project, I have some bits to try on the plexiglass.

[scottp55]

Thanks Scott,
Good to know as I bought some for my Lemur project:)
Haven't played with any of the Photo carves yet.
Never bought the PhotoVCarve standalone either, but ya never know:)

Good luck on plexi!
Got a little weather here:)
Phone down, multi second power blips and full outage expected in a few hours.
At least I'm 55F, and don't have Iguanas falling out of trees like in Florida:)
Had a 14" snowpack yesterday...watching bare ground reappear in real time as 2" of rain falls:)
All I need is for some decent branches to fall where I can reach them now:)
Merry Christmas!
scott

[rtibbs]

At least I'm 55F, and don't have Iguanas falling out of trees like in Florida:)
Had a 14" snowpack yesterday...watching bare ground reappear in real time as 2" of rain falls:)
Merry Christmas!
scott

Haven’t noticed any Iguanas falling from the trees yet but it is colder down here in FL than where you are. Go figure

Snow. I don’t miss it. I lived in NH for eleven years and had my fill of the stuff. Remember the days when my snowblower couldn’t throw it high enough.

Stay safe,
Ron