My First job for test with Cut 3D

Post by **CNC-Wood** » Fri May 09, 2008 9:13 pm

Its my first job for testing Cut 3D, the Modeli´l get from http://www.vectorart3d.com

The Material where i engrave it, is Corian , the big one has 8 cm Diameter, and the smal one 3 cm.

Regards Stefan

Post by **Thkoutsidthebox** » Fri May 09, 2008 9:58 pm

Looks good.

What size bit did you use on the small one, it seems to have very nice detail for such a small piece?

Post by **CNC-Wood** » Fri May 09, 2008 10:13 pm

The bit was a Ball Nose with 1 mm Diameter , The same by the big one.

Stefan

Post by **JamesB** » Sat May 10, 2008 3:10 am

Very nice Stefan, glad it worked out for you. I hope your CNC information weekend was a success. Regards,
James