Is it possible to mix a Cut3D model with a VcarvePro model? How is it done? If its possible. Do I have to create two separate models using the same dxf geometry?
I have this idea to make a trophy. I want to model an airplane and setup the tool paths with 3dcuts, but the text would be done in VcarvePro.
Thanks
Dave
New to Cut3D and I have a question about mixing models
- DavidCousins
- Vectric Wizard
- Posts: 359
- Joined: Sat Mar 17, 2007 2:56 pm
- Location: Huntsville, Alabama
- DavidCousins
- Vectric Wizard
- Posts: 359
- Joined: Sat Mar 17, 2007 2:56 pm
- Location: Huntsville, Alabama