KJ3030 Drivers

Post by **gcb0909** » Sat Apr 25, 2015 1:57 pm

Hi all can anyone help me out, I have a ToolTec KJ3030 Machine, fairly new to it all, and trying out the Bowl sample file.
However it will not allow me to save the file as a .TAP and my machine is not listed in the Postprocessor list, Manual says download the drivers....................where from
Any help gratefully received

Post by **Adrian** » Sat Apr 25, 2015 4:07 pm

What is the controller software that you use for that machine? That's the most important thing with which Post Processor to use when you save the toolpath file. A lot of machines use Mach3 so people will use that regardless of the make of their machine.

Drivers are usually the software components that you install on the controller PC for the controller software to communicate with the CNC itself.

Post by **gcb0909** » Sat Apr 25, 2015 4:42 pm

Hi I am afraid I do not know, what you mean,

Post by **gcb0909** » Sat Apr 25, 2015 4:43 pm

2nd thoughts I am using Bravo Prodigy if that helps

Post by **Mark** » Sun Apr 26, 2015 9:38 am

Hello,

The standard G-Code Arcs post processors included with Cut3D work fine
with the machine that you have mentioned.

I hope that this helps,

Cheers,

Mark.

Post by **gcb0909** » Mon Apr 27, 2015 1:06 pm

Thanks Mark will try it out later

Vectric Customer

KJ3030 Drivers

KJ3030 Drivers

Re: KJ3030 Drivers

Re: KJ3030 Drivers

Re: KJ3030 Drivers

Re: KJ3030 Drivers

Re: KJ3030 Drivers