Hi,
Is there a post processor for CaMaster Stinger 1 for Cut3D??
If yes where can I get it?
Post processor
- Adrian
- Vectric Archimage
- Posts: 14544
- Joined: Thu Nov 23, 2006 2:19 pm
- Model of CNC Machine: ShopBot PRS Alpha 96x48
- Location: Surrey, UK
Re: Post processor
It's the control software that is the important thing for which Post Processor you use rather than the make of the actual hardware. Not sure if the Camaster's run Mach3 or WinCNC. If someone doesn't come along here with a definitive answer you could try the www.camheads.org forum. I know there are Post Processors for Cut3D and your machine there.
-
- Vectric Craftsman
- Posts: 182
- Joined: Tue Oct 06, 2009 4:45 pm
- Model of CNC Machine: Self built 36x25x7
- Location: Hopewell, Ohio
Re: Post processor
Claude,
I think you get that from your owners forum at Camaster.
I think you get that from your owners forum at Camaster.
- ssflyer
- Vectric Wizard
- Posts: 912
- Joined: Wed Nov 26, 2008 8:21 pm
- Model of CNC Machine: ShopBot PRSAlpha 96x60
- Location: Napa County, California
Re: Post processor
Hi Claude,
You can find them, HERE.
Be sure to read all the details in the post - CAMaster Single Tool (no arcs) IN.pp is the one that must be used with Cut3D.
Hope this helps...
You can find them, HERE.
Be sure to read all the details in the post - CAMaster Single Tool (no arcs) IN.pp is the one that must be used with Cut3D.
Hope this helps...
Ron Sloan
-
- Vectric Apprentice
- Posts: 89
- Joined: Tue Mar 25, 2014 9:45 am
- Model of CNC Machine: CaMaster Stinger 1
- Location: Canada, Quebec
Re: Post processor
Hey Thanks SS!
Really appreciate .
Respect
Claude
Really appreciate .
Respect
Claude