Putter head

This forum is for general discussion about Cut3D
Post Reply
Retired 1st Sgt
Vectric Apprentice
Posts: 78
Joined: Tue Jun 24, 2014 3:58 pm
Model of CNC Machine: Laguna IQ

Putter head

Post by Retired 1st Sgt »

I’m wanting to create a golf putter head. Has anyone done this yet?

Retired 1st Sgt
Vectric Apprentice
Posts: 78
Joined: Tue Jun 24, 2014 3:58 pm
Model of CNC Machine: Laguna IQ

Re: Putter head

Post by Retired 1st Sgt »

I’m guessing that’s a no?😂

User avatar
Rcnewcomb
Vectric Archimage
Posts: 5887
Joined: Fri Nov 04, 2005 5:54 am
Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
Location: San Jose, California, USA
Contact:

Re: Putter head

Post by Rcnewcomb »

Well, it's not a putter, but on DesignAndMake.com....
Club Head No.1.jpg
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop

User avatar
mtylerfl
Vectric Archimage
Posts: 5865
Joined: Thu Jan 29, 2009 3:54 am
Model of CNC Machine: -CarveWright CNC -ShopBot Buddy PRSAlpha
Location: Brunswick, GA

Re: Putter head

Post by mtylerfl »

Retired 1st Sgt wrote:
Fri Jul 15, 2022 2:51 am
I’m wanting to create a golf putter head. Has anyone done this yet?
I don’t know if anyone here has made any wooden putters. I found a weblink that has dimensions required for a “legal” putter (made from any material) as well as some info about wooden putters:

https://primeputters.com/are-wood-putters-legal/
Michael Tyler

facebook.com/carvebuddy

-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC

Retired 1st Sgt
Vectric Apprentice
Posts: 78
Joined: Tue Jun 24, 2014 3:58 pm
Model of CNC Machine: Laguna IQ

Re: Putter head

Post by Retired 1st Sgt »

Thanks

Post Reply