This forum is for general discussion about Cut3D
Post Reply
Posts: 1
Joined: Sun Apr 04, 2021 8:43 am
Model of CNC Machine: Stepcraft 840


Post by olivier3 »

Hi all,

I recently had to reinstall Cut3d because I had a crash of my hard drive.

Reinstall goes well, but I can only save my file on Anilam_mm.pp. uccnc doesn't accept it...

How to have droplist reinstall correctly and also, what is «the best» format to use with Uccnc ?


User avatar
Vectric Wizard
Posts: 4584
Joined: Fri Nov 04, 2005 5:54 am
Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
Location: San Jose, California, USA

Re: postP

Post by Rcnewcomb »

You may wish to send an email to for the best answer.
- Randall Newcomb
10 fingers in, 10 fingers out
another good day in the shop

Post Reply