1/8" ballnose at 8% step over for about 35 minutes
About 8" diameter
Praying Hands in Hard Maple with cherry glaze
Moderator: Todd Bailey
-
Rcnewcomb
- Vectric Archimage
- Posts: 5908
- Joined: Fri Nov 04, 2005 5:54 am
- Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
- Location: San Jose, California, USA
- Contact:
Praying Hands in Hard Maple with cherry glaze
- Attachments
-
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop
10 fingers in, 10 fingers out, another good day in the shop
-
metalworkz
- Vectric Wizard
- Posts: 2463
- Joined: Mon Mar 31, 2008 3:26 am
- Model of CNC Machine: SX3 CNC, DIY 24x20 & 48x60 routers
- Location: Modesto, California 95358 USA
Re: Praying Hands in Hard Maple with cherry glaze
Hi Randall,
The praying hands looks great. Only 35 minutes, what do you use for a cutting pass depth and feed rate on these?
The praying hands looks great. Only 35 minutes, what do you use for a cutting pass depth and feed rate on these?
-
Bob Reda
- Vectric Wizard
- Posts: 858
- Joined: Wed Aug 16, 2006 7:34 pm
- Model of CNC Machine: shopbot 48x48 upgraded prt
- Location: Monessen, Pa
- Contact:
Re: Praying Hands in Hard Maple with cherry glaze
nice work
Bob
Bob
-
Rcnewcomb
- Vectric Archimage
- Posts: 5908
- Joined: Fri Nov 04, 2005 5:54 am
- Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
- Location: San Jose, California, USA
- Contact:
Re: Praying Hands in Hard Maple with cherry glaze
full depth since it was a final toolpath. At 8% stepover most of the cutting is done by the side of the bit but it is only taking 0.010" of material per pass. This is where the tapered ballnose bits from Gary Beckwith really perform well.what do you use for a cutting pass depth and feed rate on these?
6ips (360 ipm) XY&Z speeds
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop
10 fingers in, 10 fingers out, another good day in the shop