Vectric Customer

Something happened because all is working well now

Roly

I have the same problem. In the new style forum none of the categories will show me that there are new posts. As a result I have to also look and try to remember what I have and have not read. At least it keeps me coming back on a daily basis. Hate to think what is going to happen when I go away for...

Don't know what happened then I posted a reply and it seemed to disappear into the ether. Chuck and Jason, I have attached the file for the celtic knot I was doing but the police badge was way too big. The knot came out a definite ellipse but still looke good. If you could have a look it would be mu...

Hi,

I have just had some major problems with inconsistent depths. It turned out that I had not set my steps per rev correctly but now I have done this I have had no problems with depth.

Regards
Roly from Batlow

HI guys,

Just a real short question, Has anyone else had the problem that their circles are not coming out as circles but rather as elipses. I don't know wether it is with Vcarve or again with my post processor.

Roly from Batlow
Australia

Hi guys, I hope you can help.. I was trying to cut some pockets to make a business card holder for the shop and thiought that I had modified the tool to take a 2.5mm cut with two or three passes to make the 10mm depth I was looking for. Firs plunge went to 6mm in one go and the second, before I stop...

Awesome, that is something I have been tryong to get into for ages. How did you cut the gears. I am having big problems getting anything like that to cut properly. Is it possible to post the crv file for one gear which would give me a good start to understanding how to go about cutting the others. T...

Bradmeister,

Thank you very much for your reply. I will go and try it and post some pictures.

Thanks again,
Roly

Hi guys Just a short question. I make the odd pen out of different materials and thought it would be good if I could engrave or very lightly v-carve a logo a message or name into the wood or whatever the pen is made from. This entails v-carving onto a curved surface albeit a very slight curve. Is th...

Hi all, I am finally getting close to getting my machine up and running. I have been busily preparing for the first project and have been playing with VCarve learning how to use the program. I am most mightily impressed but have one small problem. If in my project I specify a thickness of .5 inch an...

Hi guys,

Thank you all very much for your help. I can start getting into the cutting now when I get my machine back up and working again. Should be set within the next fortnight.


Roly

Hi to you all out there.

On the home page there are some pictures of cog wheels and they look very good, can anyone help me with how they are cut/carved and can it be done on v-carve pro.

Thanks in advance
Roly at Batlow